EonNAS Pro Series Hardware Manual
3. Open th
e tray bezel by pushing the release button (indicated by the blue
arrow) and the front bezel will automatically open.
4. Remove the drive tray by pulling it one inch away from the drive bay. Wait for
at least 30 seconds for the hard drive to spin-down, and then gently and
carefully remove the drive tray from the chassis.
5. Remove the four (4) retention screws that secure the hard drive from the
sides of the drive tray (two on each side).
6. Install the replacement hard drive as shown below and reinserted into the
enclosure (or refer to Installing Hard Drives
).
Connector end
57
To Next Page
Loading...
