WARNING
Switch off the terminal before opening the battery door.
4.2.2 MicroSD Memory Card
MicroSD connector is located inside the terminal, in a closed compartment.
Turn the terminal and remove the battery door.
MicroSD are identified by the engraved marks on the lower housing.
Slide the cover to the end and pull to open it. Insert MicroSD card, push
the cover to close and slide it to the top to lock it. Be sure to put the
MicroSD card contacts downside and the cut corner as indicated on the
figure.
Close the battery door.
The terminal supports MicroSD up to 32GB.
14
AXIUM DX4000 Portable
10/24
Copyright© 2022 Ingenico –
Banks and Acquirers International Holding SAS
All rights reserved
To Next Page
Loading...
