Ingenico iUP 250 - Page 16

Intégration Guide_iUP250&iUR250 16/83 Copyright © 2012 Ingenico
900009151 R11 000 01/1223 All rights reserved
1.3.1.2.1 Ethernet
The IUP250 PINPad unit can be connected to Ethernet. The connector type is
shielded RJ45.
The Ethernet cable is standard and not provided.
The Ethernet cable must be shielded.
1.3.1.2.2 USB device
The IUP250 PINPad unit can be connected by type B USB.
1.3.1.2.3 USB host
The iUP250 PINPad unit can drive 4 USB accessories. The connector is standard
type A.
The power available is limited to 1.2A Max dispatched between the 4 USB.
1.3.1.2.4 Wake-up mechanism
iUP250 is design to save power thanks to a “stand-by mode”.
To wake-up iUP250, press green key or use Wake-up mechanism.
Pin 2 of COM0 link & COM2 link drive the wake-up mechanism.
Wake-up pin state
Hz (high impedance)
Stand-by authorized
Drive to “0”
Wake-up / Stand-by unauthorized
The Wake-up pin is drive to “0” by the one asking the wake-up.
It could be driven by iUR250, iUP250 or any devices designed to be compliant (Host
device…).²
PINPad
iUP 250
Card Reader
iUR 250
USB
COM0
1 - GND
2 - Wake-up
3
4
5
6
COM0 & 2
1 - GND
2 - Wake-up
3
4
5
6
USB
Any devices design to be compliant.
HZ => Stand-by
« 0 » => Wake-up
HZ => Stand-by
« 0 » => Wake-up
HZ => Stand-by
« 0 » => Wake-up
Do not connect
DC PLUG