Intégration Guide_iUP250&iUR250 72/83 Copyright © 2012 Ingenico
900009151 R11 000 01/1223 All rights reserved
9 MAINTENANCE
9.1 CONFIGURATION
The iUP250 & iUR250 supplied to you has operational configuration loaded.
In factory, softwares are loaded in the iUP250 & iUR250, as well as parameter
definition files.
The parameter definition file of the UCMC component is used, in particular, to
determine the type of printer used (local/host) and the position of the host (COMx).
To change configuration, you must load a new parameter definition file (supplied by
Ingenico).
This operation can be performed using the LLT or a USB key (see § Loading by USB
key)
For more information concerning configuration, contact Ingenico Technical Support.
9.2 PRODUCTS COMMISIONNING
Please refer to ICO/ETU/11/1849/YM : Commissioning User's Guide.
To be able to perform the commissioning procedure the anti-removal must be
correctly mounted see chapter 6.2 for iUR250 and 7.2 for iUP250.
To Next Page
Loading...
