Intégration Guide_iUP250&iUR250 22/83 Copyright © 2012 Ingenico
900009151 R11 000 01/1223 All rights reserved
1.3.1.3 SAM & µSD Installation
1. Disconnect the iUP250 from the main power supply.
2. Open the SAM door by removing the screw.
3. Insert the SAM cards in SAM slot 1 and /or slot 2
4. Insert µSD card in µSD slot
5. Insert SIM card in SIM slot.
6. Slide the SAM door and screw.
For SAM/SIM cards, take care of cards
orientation and do not push in excess the cards.
After insertion, the cards position is 4 mm
out of the products as shown on picture.
1.3.1.4 Buzzer
The buzzer is controlled by application. The frequency depends of software.
To Next Page
Loading...
