Intégration Guide_iUP250&iUR250 58/83 Copyright © 2012 Ingenico
900009151 R11 000 01/1223 All rights reserved
6.2 KIOSK PREPARATION FOR IUR250 INSTALLATION
The iUR250 requires a cut out in the kiosk (dimensions in millimetres detailed in
the diagram below).
CAUTION:
The equivalent iUR250 hatched footprint surface on the kiosk must be flat and
clear of any holes and burrs.
Special attention is required for the area of anti-removal switches.
Fixing must be done by 4 M4 to M6 x12mm welded studs.
Cut-out drawing for iUR250.
3D design on demand.
To Next Page
Loading...
