For security reasons, we recommend that you disable the default user account and
create your own.
3.1.1 Connecting via the SSH Console
The EC300 supports SSH connections over Ethernet. Connect to the EC300 using the
following default IP address.
3.1.1.1 Linux users
Tips
These steps apply if you are connecting to EC300 on a Linux PC. Please do
not apply these steps to the EC300 device itself. Before you run the ssh
command, be sure to configure your PC's Ethernet port IP address to be
within a specific range. ETH1:192.168.3.0/24, ETH2:192.168.4.0/24.
Use the ssh command to access the ETH1 port of the EC300 on a Linux PC.
Type yes to continue to complete the connection.
When the terminal prompt edge@edge-computer:~$appears and shell commands can be
entered, the connection is successful.
To Next Page
Loading...
