3.3.1.2.3 Configure the Wi-Fi Station
Enable Wi-Fi: Enable the switch; Off by default
Client SSID: The ssid you want to connect to, you can enter it manually; You can also use the
scan button to get nearby SSIDs that you can connect to
Enable Default Route: Enable the function of adding default route. If enabled, when the wifi
connection is successful, a default route of wlan port will be added. The default route is
enabled.
Metric: This is the metric for the default route of the wifi port. When the default route is
configured for the cellular, Wi-Fi, and Ethernet ports, the metric with the lowest value is
applied.
Auth Method: Auth method, supports no auth, WPA-PSK, WPA2-PSK, WPA-PSK/WPA2-PSK Mixed
-Sheldon: Encrypt Mode. CCMP, TKIP, TKIP and CCMP are supported
WPA/WPA2 PSK Key: Key information
3.3.1.2.4 Configuring static routes
This is a static routing for Ethernet. When the default routing for Ethernet, cellular, and
wifi is configured, the default route with the lowest metric value will take effect. You need
to make sure that the Metric value of the default route is different.
To Next Page
Loading...
Need help?
General
