INIM Electronics Prime Series

Installation manual
The control panel and peripherals 17
Keypad terminals:
Terminals T1 and T2 can be configured as:
• Input (also as Rollerblind or Shock)
•Output
•Double zone
• Supervised Output
The keypad package contains a sticker (to be located under the keypad flip) which can be
used to note down the keypad address or label, its location, the partitions it controls and any
phone-contact numbers.
Table 2-11: Joy - description of parts
Model JOY/GR JOY/MAX
A Termina l b oard
B Buzzer
C /Microphone
D /Temperature sensor
E Open-tamper microswitch
F Backlit graphic display
G Signaling LEDs
H /Antenna
I / Speaker wire connector
J Wire entry
K Wall-mount screw locations
L Speaker housing
M Board supports
N Dislodgement-tamper microswitch screw location
O Dislodgement-tamper microswitch spring
A
B
C
E
G
H
K
L
D
F
K
K
K
K
K
K
M
M
M
I
J
O
N
JOY keypad board
JOY keypad backbox
Table 2-12: Joy - terminal board
n. identifier description
1+
Termina l “ + ” for the connection of the I-BUS
2D Termin a l “ D ” for the connection of the I-BUS
3S Termin a l “ S ” for the connection of the I-BUS
4- Termina l “ - ” for the connection of the I-BUS
5T1 Screw terminal of keypad terminal T1
6 Negative power terminal (Negative or GND)
7T2 Screw terminal of keypad terminal T2
8 Negative power terminal (Negative or GND)
1 2 3 4 5 6 7 8
A