INIM Electronics Prime Series - 5-1 Managing alarms

20 The control panel and peripherals
Anti-intrusion control panels
You can connect Code/G and Concept/G keypads using the connector on the back of the
device, using either the 6 wire cable (included), or the KB100 terminal board included in the
deep-bracket kit (accessory kit).
nCode/G and Concept/G keypads are equipped with a buzzer and a T1 terminal which can be
configured as:
• Input (also as Rollerblind or Shock)
•Output
•Double zone
2-3-4
Alien/G and Alien/S touch screen keypads
• 65000 colour display
• Touch-screen
• Protection against removal and dislodgement tamper
• Input/Output terminals (Alien/G only)
• Thermometer and chronothermostat function
• Microphone and loudspeaker for voice functions
• Built-in proximity reader
• System interface with I-BUS (and BUS RS485, for future use)
•USB Interface
• SD card interface
• Photoframe function with images on SD card
• Background customization with images on SD Card
• Skin selection
• Colours available: black or white
Table 2-18: Brackets - description of parts
I Wire entry
L Wall-mount screw locations
M Flush-mount screw locations
N Backlocking grips
I
M
Mounting bracket
M
L L
L
L
N
N
N
N
N
KB100 - deep mounting bracket
I
M
M
L L
L
L
N
N
N
N
N
L
L
L
Table 2-19: Connection cables - KB100 terminal board
n. colour
KB100 termi-
nal board
description
1Red +
Wire/Terminal “ + ” for the I-BUS connection
2 Yellow D Wire/Terminal “ D ” for the I-BUS connection
3Green S Wire/Terminal “ S ” for the I-BUS connection
4 Black - Wire/Terminal “ - ” for the I-BUS connection
5 Blue T1 Wire/terminal of keypad terminal T1
6 Black Negative power wire/terminal (Negative or GND)