INIM Electronics Prime Series

Installation manual
The control panel and peripherals 19
Terminals T1 and T2 can be configured as:
• Input (also as Rollerblind or Shock)
•Output
•Double zone
• Supervised Output
2-3-3
nCode/G and Concept/G Keypads
• Backlit graphic display
• Icon Easy4U interface
•4 indicator LEDs
• Signal buzzer
• Tamper protection
• Mounts to “503” outlet boxes, vertical position
• 1 Input/Output terminal
Blue T1 Wire/terminal of keypad terminal T1
Black - Negative power wire/terminal (Negative or GND)
Grey T2 Wire/terminal of keypad terminal T2
Black - Negative power wire/terminal (Negative or GND)
Table 2-15: Aria/HG - connection wires
colour terminal description
Table 2-16: nCode/G, Concept/G - electrical and mechanical features
Model nCode/G Concept/G
Voltage
from 9 to 16V
Typical current draw 70mA 80mA
Terminals configurable as OC outputs 1
Maximum current draw per terminal 150mA
Dimensions (W x H x D) 87 x 129 x 18 mm 87 x 129 x 16.5 mm
Weight 135g 155g
Buttons
23
(in soft rubber)
23
(touch)
Table 2-17: nCode/G and Concept/G - description of parts
A
Backlit graphic dis-
play
B Signaling LEDs
C Cable connector
D Tamper microswitch
E Screw location
F Screw location
G
Terminal board
guide
H Buzzer
A
B
nCode/G keypad frontplate
A
B
Concept/G keypad frontplate
C
E
D
F F
F
F F
G
H
G
Retro keypads
nCode/G and Concept/G Keypads
6 wire cable KB100 - terminal board