INIM Electronics Prime Series - 5-3 Arming scenarios; 5-4 Voice memo and intercom functions

22 The control panel and peripherals
Anti-intrusion control panels
Terminals T1 and T2 can be configured as:
• Input (also as Rollerblind or Shock)
•Output
•Double zone
• Supervised Output
TOUCH-SCREEN
CALIBRATION
If the touch screen of the Alien keypad does not respond to taps, you must carry out the
forced calibration process.
You can start this process by pressing and holding for 7 seconds the (Table 2-21: Alien -
description of parts, W) button which, for the Alien/G, can be reached on the PCB after
opening its casing and, for the Alien/S, can be reached through the relative hole. Once the
calibration process starts, simply follow the instructions provided by the keypad.
L
Alien/G open
E
D
E
G
H
H
Alien/G - PCB
O
R
Q
S
U
T
P
M
W
1 2 3 4 5 6 7 8 9
V
Table 2-22: Alien/S - Connection wires Table 2-23: Alien/G - terminal board
colour
Terminal
board
description n. identifier description
Red +
Cable/Terminal “ + ” of the I-BUS and RS485 BUS 1+ 14V Positive power terminal
Yellow D Cable/Terminal “ D ” for the I-BUS connection 2 - 14V Negative power terminal
Green S Cable/Terminal “ S ” for the I-BUS connection 3+ Termina l “ + ” for the connection of the I-BUS
Black - Cable/Terminal “ - ” of the I-BUS and RS485 BUS 4D Termina l “ D ” for the connection of the I-BUS
Grey B Termina l “ B ” for the RS485 BUS connection 5S Termin a l “ S ” for the connection of the I-BUS
Blue A Termin a l “ A ” for the RS485 BUS connection 6- Termina l “ - ” for the connection of the I-BUS
White REOL Wire/Terminals to establish the EOL on the RS485 7+ Termin a l “ + ” for the RS485 BUS connection
8B Termin a l “ B ” for the RS485 BUS connection
9A Termin a l “ A ” for the RS485 BUS connection
10 - Termin a l “ - ” for the RS485 BUS connection
11 T1 Screw terminal of keypad terminal T1
13 T2 Screw terminal of keypad terminal T2
12 -
14
Negative power terminal (Negative or GND)