INIM Electronics Prime Series - 5-5 Activations; 5-6 Outputs management

Installation manual
The control panel and peripherals 23
2-3-5
Readers - nBy/S and nBy/X
Reader terminals:
Note nBy/X is a registered patent
2-3-6
Flex5 Input/Output expansions
The input/output expansion board enclosure is available in two versions, which differ with
regard to the board housing:
• Flex5/P comes in the enclosure shown above. This version can be set up to monitor
dislodgement and open-enclosure tamper by inserting a jumper into connector [D], as
shown below.
• Flex5/U comes in an enclosure with on-view terminals and address DIP-Switch, as shown
opposite. It is evident that this version offers little protection to the terminals. The jumper
of connector [D] enables/disables the protection against open and dislodgement tamper of
the plastic enclosure only.
Terminals T1, T2, T3, T4 and T5 can be configured as:
• Input (Roller blind or Shock for terminals T1, T2, T3 and T4 only)
•Output
•Double zone
• Supervised Output
The T5 terminal can be configured as a dimmer output that allows the adjustment of the
current supplied to an analogue device (industrial standard 0 - 10V).
Table 2-24: nBy - electrical and mechanical features
Model nBy/S nBy/X
Voltage
from 9 to 16V
Typical current draw 40mA 35mA
Dimensions (W x H x D) 64 x 80 x 17 mm 19 x 50 x 51 mm
Weight 45g 25g
Table 2-25: nBy - description of parts
Model nBy/S nBy/X
A Terminal board
B /Buzzer
C LED
D Antenna
E
Anti-opening
and anti-dis-
lodgement
/
F Cable entry /
G
Mounting
screw hole
/
H / Light guide
I /
Mounting
screw
A
B
C
D
E
nBy/S - PCB
1 2 3 4
nBy/S - back
G
F
E
G
I
H
nBy/X
D
C
A
1 2 3 4
Table 2-26: nBy - terminal board
n. identifier description
1+
Termina l “ + ” for the connection of the I-BUS
2D Termin a l “ D ” for the connection of the I-BUS
3S Termin a l “ S ” for the connection of the I-BUS
4- Termina l “ - ” for the connection of the I-BUS