24 The control panel and peripherals
Anti-intrusion control panels
The packages of both versions of the Flex5 expansion board contain:
• Flex5 expansion board in a plastic enclosure
• Dislodgement/Open tamper jumper
• Jumper to set terminal T5 as an analogue output
• 10 resistors @ 3K9Ohm 1/4W
• 10 resistors @ 6K8Ohm 1/4W
Peripheral activity LED signals are as follows:
• fast blinking - peripheral operative and enrolled (in configuration)
• slow blinking - peripheral operative but not enrolled (not in configuration)
By means of appropriate programming it is possible to activate the buzzer on activation of
terminal T1 configured as an output.
The Flex5 expansion board terminals are as follows:
2-3-7
Flex5/DAC alternating current output expansion
The Flex5/DAC provides 5 terminals for controlling both AC and DC loads.
Each terminal can be configured as an output with the following attribute type:
• Relay, dry contact for AC or DC devices of up to 10A
• TRIAC ON/OFF, electronic contact that functions as a relay for AC devices up to 4A
maximum
• TRIAC dimmer, dimmer contact for power-choke type AC devices of up to 4A
For the technical description and installation of the Flex5/DAC refer to the manual included in
the respective package.
Table 2-27: Flex5 - electrical and mechanical features
Model FLEX5/P FLEX5/U
Voltage
from 9 to 16V
Typical current draw
30mA
Max. current across +AUX terminals
300mA
Maximum current draw for OC terminal
150mA
Dimensions including enclosure (W x H x D)
125 x 79 x 26 mm 105 x 58 x 18 mm
Weight including enclosure
103g 66g
Table 2-28: Flex5 - description of parts
A
Terminal board
B
Buzzer
C
DIP-Switch strip for peripheral device
addressing
D
Connector to enable peripheral-tamper
detection
E
Dislodgement-tamper microswitch
F
Open-tamper microswitch
G
Peripheral activity LED (where present)
H
Connector to set terminal T5 as an ana-
logue output
Table 2-29: Expansion terminal board
n. identifier description
1-2-3-4 + D S -
I-BUS connection terminals
5-6 +AUX
12V ancillary power source terminals
7-9-11-13-15 T1-T2-T3-T4-T5
Screw terminals for expansion terminals: T1, T2, T3, T4
and T5
8-10-12-14-16
Negative power terminals (Negative or GND)
To Next Page
Loading...
