INNO Instrument View 8+ - Appendix I High Splice Loss; Causes and Remedies for High Splice Loss

User’s Manual
INNO Instrument, Inc.
36
PAGE
Power Save Option
This function is important for power conservation. If the power saving function is not
set during battery pack use, the number of splice cycles will decrease.
(1) Insert a power unit and turn on the splicer.
(2) Select [Power Save Option] in [System Setting] menu.
(3) Change value of [Monitor Shut Down] and [Splicer Shut Down]
After selecting [System Information], the following messages will be shown on the
screen:
System Information
Parameter Description
Monitor Shut Down
To avoid power loss when battery is used, setting this
function turns off the power supply to the LCD monitor if
the splicer does not operate after a certain period of time.
When the power supply for monitor turns off, the LED near
the power key
[ ]
blinks. Press any key to turn on the LCD
monitor.
Splicer Shut Down
Automatically turns off the power supply of the splicer if it
performs no operation for a long period of time. The function
serves to prevent the battery capacity from running low.
Parameter Description
Machine Serial NO. Display the fusion splicer’s serial number.
Software Version Display the fusion splicer’s software version.
FPGA Display FPGA’s version.
Total Arc Count Display total arc discharge count.
Current Arc Count
Display arc discharge count after electrode change. The
parameters will be zero cleared or reset after replacing
electrodes.
Last Maintenance Display maintenance date at last time.
Production Date Display the date of production of the machine.