INNO Instrument View 8+ - Troubleshooting Common Issues; Power and Battery Issues; Display and Loss Errors; Sleeve and Password Issues

User’s Manual
INNO Instrument, Inc.
43
PAGE
★
Contact your nearest sales agency.
12. No arc power change after [Arc Calibration]
★
An internal factor is calibrated and adjusted for the specic arc power selected.
The displayed arc power in each splice mode does not change.
13. Forget to put the optical ber during the process of maintenance function
★
It is invalid to press the return key. You need to open the wind cover and put the
prepared bers and press the “SET” or “RESET” button to continue
14. Fail to upgrade
★
When users use the "new" U-disk to upgrade, the splice may not be able to
correctly identify the upgrade program le; you need to reset the U-disk, and restart
the splicer.
★
Check whether the upgrade le name and the format are correct.
★
If you cannot solve the problems, please contact the manufacturer directly.
15. Others
★
Please refer to the training video in detail.