Machine startup / stop
SV 125
4016589
Version 1.0
6--4
6.2.2 Automatic mode
In Automatic mode all machine operations are performed automatically. All safety
devices are active.
WARNING!
During machine operation dangers can arise.
Ensure that nobody is endangered by the machine starting up.
Only operate the machine with fully functional safety and protection
devices.
Observe safety instructions!
Mode of procedure
1
Turn the key --switch on the operator panel to the left.
2
Withdraw key from key--switch.
3
Switch on the control voltage.
4
Check error display, eliminate any present faults and reset with control field
.
5
Touch control field and keep it pressed for 3 s to switch on the machine
drive.
6
Touch control field to open the infeed gate (tub stopper 1).
7
Feed tubs with nests.
To Next Page
Loading...
Need help?
General