Cleaning and maintenance
SV 125
4016589
9-- 12
Version 1.0
9.3 Maintenance and care
DANGER!
For all mechanical maintenance and repair work the compressed air
supply disconnecting device must be turned off.
For all electrical maintenance and repair work the POWER supply dis-
connecting device on the control cabinet additionally must be set to po-
sition OFF ”0” and locked to prevent it from being turned back on acci-
dentally.
9.3.1 General
Optimum u se of the machine can only be ensured, if it is also serviced optimally,
regularly and thoroughly. The following maintenance tasks should be carried out:
S Check the wear parts
S Check the control elements for correct functioning
S Lubricate
S Clean all object --conveying parts (daily).
NOTE
Because of the machine conception change of grease or oil is not ne-
cessary.
Lubricate sparingly!
Avoid mixing different lubricants.
The machine is mainly fitted with lifetime--lubricated ball bearings.
Sub--supplied parts
For sub-- supplied parts installed on the machine, the manufacturer’s maintenance
and service instructions apply. See extra folder with operating manuals of sub --sup-
plied parts.
To Next Page
Loading...
Need help?
General