‑9‑
● Follow the proper electrostatic discharge (ESD) procedure and wear an anti‑static wrist
strap to perform wiring. Failure to comply may result in damage to the equipment or to
the internal circuit of the product.
● Use shielded twisted pairs for the control circuit. Connect the shield to the grounding
terminal of the equipment for grounding purpose. Failure to comply will result in
equipment malfunction.
Power-on
● Before power‑on, check that the equipment is installed properly with reliable wiring and
the motor can be restarted.
● Check that the power supply meets equipment requirements before power‑on to prevent
equipment damage or a fire.
● After power‑on, do not open the cabinet door or protective cover of the equipment,
touch any terminal, or disassemble any unit or component of the equipment. Failure to
comply will result in an electric shock.
● Perform a trial run after wiring and parameter setting to ensure the equipment operates
safely. Failure to comply may result in personal injuries or equipment damage.
● Before power‑on, check that the rated voltage of the equipment is consistent with that of
the power supply. Failure to comply may result in a fire.
● Before power‑on, check that no one is near the equipment, motor, or machine. Failure to
comply may result in death or personal injuries.
Operation
● The equipment must be operated only by professionals. Failure to comply will result in
death or personal injuries.
● Do not touch any connecting terminals or disassemble any unit or component of the
equipment during operation. Failure to comply will result in an electric shock.
To Next Page
Loading...
