‑27‑
In case of vertical installation:
● PLC must be installed below all I/O modules.
● Hold the cables with a cable duct to prevent the weight of cables being
applied to the lower end plate, which may result loose of the PLC from the
DIN rail.
2.3 Installation Precautions
● Before installing or removing the master and module, ensure that the master and
module are powered off.
Do not connect/disconnect the module with power ON. This may lead to master
restart or user data loss or damage.
● Prevent the master, module enclosure, or terminals from dropping or suffering
from impact or shock.
2.4 Mounting Dimensions
The mounting dimensions (in mm) are shown in the figure below.
To Next Page
Loading...
