Inovance IS300 Series - Default Chapter; Table of Contents

Contents
FOREWORD ....................................................................................................I
CHAPTER 1 SAFETY AND PRECAUTIONS..............................................- 2 -
1.1 Safety precautions.................................................................................- 2 -
1.2 Precautions............................................................................................- 5 -
CHAPTER 2 PRODUCT INFORMATION....................................................- 8 -
2.1 Designation Rules..................................................................................- 8 -
2.2 Nameplate .............................................................................................- 8 -
2.3 IS300 Servo Driver Series .....................................................................- 9 -
2.4 Technical Specifications ......................................................................- 10 -
2.5 Physical Appearance and Dimensions of Mounting Hole ....................- 13 -
2.6 Optional Parts ...................................................................................- 19 -
2.7 Routine Repair and Maintenance of servo driver.................................- 20 -
2.8 Instructions on Warranty of Driver .......................................................- 22 -
2.9 Prototyping Guide................................................................................- 22 -
2.10 Guide to Prototyping of Brake Components.......................................- 23 -
CHAPTER 3 MECHANICAL AND ELECTRIC INSTALLATION ...............- 27 -
3.1 Mechanical installation......................................................................- 27 -
3.2 Electrical Installation............................................................................- 31 -
CHAPTER4 OPERATION AND DISPLAY.................................................- 45 -
4.1 Introduction to Operation and Display Interface...................................- 45 -
4.2 Description of Function Code Viewing and Modification Methods .......- 48 -
4.3 Shortcut Menu Operation Mode ........................................................- 49 -
4.4 Method of Viewing Status Parameter ..................................................- 51 -
4.5 Password Setting.................................................................................- 51 -
4.6 Automatic Tuning of Motor Parameters ...............................................- 52 -
CHAPTER 5 FUNCTION PARAMETER TABLE.......................................- 55 -
CHAPTER 6 PARAMETER DESCRIPTION..............................................- 89 -
Group U0 Driver parameters viewing group............................................- 89 -
Group A0 Weak magnetism and SVC control group (SAV control reserved).-
89 -
Group A1 PG Card Group.......................................................................- 90 -
Group A2 CAN Communication Group ...................................................- 91 -
Group F0 Basic Function Group..............................................................- 97 -
Group F1 Motor Parameters .................................................................- 106 -
Group F2 Vector Control Parameters....................................................- 109 -
Group F3 V/F Control Parameters ........................................................- 114 -
Group F4 Input Terminal.......................................................................- 117 -