Function Parameter Table MD280/MD280N User Manual
- 68 -
Chapter 5 Function Parameter Table
When FP-00 is set to non-zero value, it means that the parameter
protection password is set and only when correct password is input can the
user enter the parameter menu. To cancel the password, it needs to set
FP-00 to 0.
The parameters in the shortcut menu are out of password protection.
The symbols in the function table are explained as follows:
“ ” indicates that the parameter setup value can be modified when the ƿ
inverter is in stop status and running status;
“ ” indicates that the parameter setup value cannot be modified when the ƾ
inverter is in the running status;
“Ɣ” indicates that the parameter value is the actual detection record and
cannot be modified.
“*” indicates that the parameter is “Factory default parameter” and can be
set only by the manufacturer, and the user is forbidden to perform any
operation.
efesotomasyon.com
To Next Page
Loading...
