50 | support@instantpot.com.au | 1800 251 643
CARE, CLEANING AND STORAGE
WARNING
The multicooker base contains electrical components. To avoid fi re, electric leakage and/
or personal injury, make sure the multicooker base always stays dry.
• DO NOT immerse the multicooker base in water or other liquid or attempt to cycle
it through the dishwasher.
• DO NOT rinse the heating element.
• DO NOT submerge or rinse the power cord or the plug.
Removing and installing parts
Silicone sealing ring
Remove the sealing ring
Grip the edge of the silicone and pull the
sealing ring out from behind the circular
stainless-steel sealing ring rack.
With the sealing ring removed, check
the ring rack to make sure it is secured,
centered, and an even height all the way
around the lid. Do not attempt to repair a
deformed ring rack.
Instant Tip: The sealing ring is
easiest to remove when it is wet
and soapy.
Install the sealing ring
Place the sealing ring over the sealing ring
rack and fi rmly press it into place. Make
sure there’s no puckering.
It should be snug behind the sealing
ring rack. It can wiggle a bit but shouldn’t
fall out when you turn over the lid.
To Next Page
Loading...
Need help?
General
