Instron 34TM-50 - Bluehill Operator Dashboard

Chapter: Installation
44 M10-17318-EN
Caution
Frames may not be able to run at rated speeds if connected to a power supply more
than 10% below the configured voltage.
10. Connect the mains power cable to the IEC connector on the rear of the machine and
to the electrical power supply (see “Dual column table model load frame” on
page 37).
11. Connect the mains power cable on the Bluehill
®
Operator Dashboard to the electrical
power supply.
The system is now ready to be turned on. Refer to “First time startup” on page 47.
Bluehill
®
Operator Dashboard
The Bluehill
®
Operator Dashboard provides a touch-friendly interface for controlling your
testing machine using Bluehill
®
software.
Adjustment and connection
Instron
®
Service will install the Bluehill
®
Operator Dashboard on your system.
1. You can adjust the height of the Bluehill
®
Operator Dashboard for the comfort of
different operators. Loosen the lock (1 in Figure 11 on page 45) and slide the arm
mounting (2 in Figure 11 on page 45) to the desired height. Re-tighten the lock.