83
Adapters
Product Support: www.instron.com
Base adapters
Base adapters let you connect grips and fixtures to the base of the load frame. The load
frame is supplied with a Type D base adapter installed. If you need to remove and re-
install the base adapter, for example to change the orientation, use the following
procedures.
Remove the base adapter
1. Remove the compression spring located inside the adapter.
2. Insert a 14 mm hex key into the base adapter, ensuring that it fits into the screw at
the base of the adapter.
3. Loosen and remove the screw inside the adapter.
4. Lift the adapter away from the base beam.
To Next Page
Loading...
