3-7
Transporting Dual Column Frames
Product Support: www.instron.com
“Crosshead Method” on page 3-7 to remove the shipping skid, insert the leveling feet
and position the frame.
When the frame is in its operating location, you can proceed with the installation process.
Crosshead Method
This method requires protective padding on either the crosshead or forklift arms to protect
the crosshead from scratching or marring.
This method can be used to:
• Transport the load frame to the site location.
• Lift a tabletop load frame onto a table or workbench.
• Lift the frame to remove the transport skid from the frame’s base and to insert the
leveling feet.
To transport the load frame using the crosshead method:
1. Ensure that there are no shipping bolts attached to the skid.
2. Using a forklift with padded forks or protective material around the crosshead, carefully
insert the forks under the crosshead between the columns. Refer to Figure 3-2 on
page 3-7.
Figure 3-2. Lifting the Frame from the Crosshead
Leveling feet
Crosshead
Forklift arm
To Next Page
Loading...
