InstroTek Auto_SCB - System Location; System Specifications

InstroTek
5
2. System Location
When setting up this unit, please select a location that can
meet the minimum requirements below.
1. The unit is designed to be a bench-top unit. Provide
adequate space for the user to utilize the control
screen and insert the SCB jig from the front of the load
frame.
2. Set the unit on a level and stable surface. It is
recommended that the unit be leveled before testing
using the attached feet.
3. System Specifications
 Dimensions: 20” W x 18” L x 57” H
 Weight: 300 lbs.
 Displacement Speed: 0.01 – 51 mm (0.0004 – 2.0 inch)
per minute
 Electrical Requirement: 120VAC, 150W, 1.5A
 Maximum Ram Travel: 100 mm
 LVDT Maximum Displacement: 25 mm
 Load Capacity: 10 kN (2,200 lbs.) and optional 50 kN
(11,000 lbs.)