16. Test Archive
This function allows the user to review any tests that are stored
on the USB thumb drive currently attached to the machine. The
same functions that are available at the end of the test are
available in the Test Archive to review the test data. See
Operation-Running a Test and Results for more information.
17. System Configuration & Calibration
The section provides information on setting system parameters
that are adjusted for optimal performance. The system
configuration is divided into two sections: Device Configuration
and Channel Configuration. The device configuration includes
parameters that control the limits of the machine including the
Home and Test positions and the data acquisition rate. The
channel configuration allows the verification and calibration of
the measurement sensors on the machine. Contact InstroTek for
instructions on how to change parameters in the System
Configuration not mentioned in this manual. These are set at
the factory and should only be changed after contacting
InstroTek.
1. Press on the main menu to enter System
configuration. Then press to enter the Device
configuration menu.
2. Enter the password (2222).
To Next Page
Loading...