Need help?Do you have a question about the InstroTek Auto_SCB and is the answer not in the manual?
General| Brand | InstroTek |
|---|---|
| Model | Auto_SCB |
| Category | Test Equipment |
| Language | English |
Includes warnings on repairs, operation without training, and disconnecting power.
Covers crushing injury prevention, facility safety, and maintenance responsibility.
Detailed steps for preparing SCB specimens, including cutting and notching.
Start test, configure sample ID, standard, profile, and load cell.
Configure pre-load settings, rate, start load, and stop criteria.
Procedure to confirm, reset, and troubleshoot system alarms.
Set system parameters for optimal performance, including limits and data acquisition rate.
Verify and calibrate measurement sensors like LVDT and load cell.
Perform calibration for the load cell (Channel 1).
Perform calibration for the LVDT (Channel 2).
To Next Page
