Advanced Operations
En-67
Operating
procedure
(➔ page 50)
■ Bluetooth
This setting enables the AV receiver to pair with
Bluetooth-enabled device.
Status
Press Enter button to display “Now Pairing” and start
pairing.
Tip
• If pairing setting is not set, “Ready” appears on-screen
display. The name of the device paired with the AV receiver
is displayed if pairing setting is set.
• For details on the Bluetooth connection, refer to the
instruction manual of the Bluetooth-enabled device.
Note
• This setting cannot be selected if you’ve selected NET or
USB as input selector in Zone 2.
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See “Initial Setup” (➔ page 21).
Note
• This setting cannot be selected if the “Monitor Out” setting
is set to “Sub”.
Remote ID
■ Remote ID
` 1
, 2, or 3
When several Integra/Onkyo components are used in
the same room, their remote ID codes may overlap.
To differentiate the AV receiver from other
components, you can change its remote ID from “1”,
to “2” or “3”.
Note
• If you do change the AV receiver’s remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won’t be able to control it with the remote
controller.
Changing the remote controller’s ID
Remote Mode Setup
See “Looking up for Remote Control Codes”
(➔ page 72).
With this preference, you can protect your settings by
locking the setup menus.
■ Setup
` Locked
` Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
8. Remote Controller Setup
1
While holding down Receiver, press and hold
down Q Setup until the remote indicator lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
9. Lock Setup
To Next Page
Loading...
