Integra DTR-30.5 - Zone 2 Operations; Setting Zone 2 Output and Controlling Components; Adjusting Zone 2 Volume, Muting, and Tone;Balance

Advanced Operations
En-69
See “Multi Zone” (➔ page 63).
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2, you must press Zone2 on the
remote controller first.
Adjusting the Volume for Zone 2
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver
or integrated amplifier in Zone 2, use its volume
control to adjust the volume.
Muting Zone 2
■ Operating on the remote controller
Tip
• To unmute, press Zone2 followed by Muting again. Zone
can also be unmuted by adjusting the volume.
Adjusting the Tone and Balance of Zone 2
Setting the Zone 2 Out
Controlling Zone 2 Components
1
To turn on Zone 2 and select an input source,
press Zone 2 followed by an input selector
button within 8 seconds.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
To select the same source as the main room’s,
press Zone 2 twice. “Z2 Sel: Source” appears on
the AV receiver’s display.
2
To turn off Zone 2, press Off.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Input selector buttons
Zone 2
Off
Tone
–, +
Zone 2 Level q/w
1
Press Zone2, then point the remote controller
at the AV receiver and press 8Receiver.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2, press
Zone2, followed by an Input Selector button.
3
To turn off Zone 2, press Zone2, followed by
8Receiver.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
1
Press Zone2.
2
Use VOL q/w.
8Receiver
Zone2
Input
Selector
VOLq/w
Muting
1
Use Zone 2 Level q/w.
1
Press Zone2 followed by Muting.
1
On the AV receiver, press Zone 2.
2
Press the AV receiver’s Tone repeatedly to
select “Bass”, “Treble” or “Balance”.
3
Use – or + to adjust the bass, treble or balance.
• You can boost or cut the bass or treble from
–10 dB to +10 dB in 2 dB steps.
• You can adjust the balance from 0 in the center
to +10 dB to the right or +10 dB to the left in
2 dB steps.