35
Turning On the AV Receiver
Standby/On
On
Receiver
Standby
Standby indicator
Turning On and Standby
Press the [Standby/On] button.
Alternatively, press the remote controller’s [Receiver] button, followed by
the [On] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
Pressing the remote controller’s [On] button again will turn on any components con-
nected via .
To turn the AV receiver off, press the [Standby/On] button, or press the remote control-
ler’s [Standby] button. The AV receiver will enter Standby mode. To prevent any loud
surprises when you turn on the AV receiver, always turn down the volume before you
turn it off.
Remote
controller
AV receiver
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Do the speaker setup—this is essential!
See “Speaker Setup” on page 36.
■ Have you connected a component to component video
input or digital audio input?
If you have, see “Component Video Setup” on page 39 or “Digital
Audio Input Setup” on page 40 respectively.
■ Have you connected an Integra MD recorder, CD recorder,
or next generation HDD-compatible component?
If you have, see “Changing the Input Display” on page 41.
OPTICAL
COAXIAL
Y
P
B
PR
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock, etc.
3ConnectionEn Page 35 Thursday, September 22, 2005 3:46 PM
To Next Page
Loading...
Need help?
General
