Integra DTR-4.6 - Changing the Input Display

41
First Time Setup —Continued
If you connect an -capable Integra MiniDisc
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 3 IN
jacks, for to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
Note:
HDD can be selected for the Tape input selector or
Video 3 input selector, but not both at the same time.
Changing the Input Display
1
Press the [Tape] or [Video 3]
input selector button so that
“TAPE” or “VIDEO3” appears on
the display.
2
Press and hold down the [Tape]
or [Video 3] input selector button
(about 3 seconds) to change the
setting.
Repeat this step to select MD, CDR, or
HDD.
For the Tape input selector, the setting
changes in this order:
For the Video 3 input selector, the set-
ting changes in this order:
VIDEO 3
↔
HDD
1, 21, 2
or
or
→ TAPE → MD → CDR → HDD
DTR-4.6.book Page 41 Thursday, September 22, 2005 1:45 PM