DTR-7.4
PANEL VIEWS
REMOTE CONTROLLER
Test Tone, CH SEL, Level - & Level+ buttons
These buttons are used to adjust the level of each
speaker individually. These functions can be set
only with the remote controller. The Level- and
Level+ buttons are also used to adjust the volume in
Zone 2.
Audio SEL button
This button is used to select the audio input signal
format: analog, digital, or multichannel.
LIGHT button
This button is used to turn on or of f the remote con-
troller's illuminated buttons.
Direct Tuning button
This button is used with the number buttons to
select a radio station by entering its frequency. Press
this button first, and then use the number buttons to
enter the frequency.
Display
The top line of this LCD display shows the name of
the currently selected input source. The bottom line
shows the currently selected remote controller
mode.
Zone 2 button
This button is used when you want to set the volume
and input source for Zone 2.
Input button
This button is used to select the input source. Press
this button first, and then roll the scroll wheel until
the name of the input source appears on the display.
Sleep button
This button is used to set the Sleep function. This
function can be set only with the remote controller.
VOL button
This button is used to set the volume of the
DTR-7.4.
Setup/Guide button
This button is used to access the onscreen setup
menus (OSD) that appear on the TV.
Muting button
This button is used to mute the DTR-7.4. This func-
tion can be set only with the remote controller.
All CH ST button
This button is used to select the All Ch Stereo listen-
ing mode.
Stereo button
This button is used to select the Stereo listening
mode.
DSP/DSP buttons
These buttons are used to select the DSP (digital
signal processor) listening modes.
Re-EQ button
This button is used to turn on and off the Re-EQ
function.
L Night button
This button is used to set the Late Night function.
To Next Page
Loading...
Need help?
General
