94
Using the Listening Modes—Continued
Notes:
*1 For 7ch output, output can be switched between Front high or Front wide speakers by pressing the [SP Layout] button (depending on the
“Speaker Configuration” setting (see page 102)).
*2 For 9ch output, output can be switched between the combination of Surround back and Front high, or Surround back and Front wide
speakers by pressing the [SP Layout] button.
*3 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better sound
according to the player. In that case, set the output setting on the player side to PCM.
*4 • This listening mode can be selected only when all the following conditions are satisfied:
a. Center speaker is connected to the AV receiver.
b. Either of Front High speakers or Front Wide speakers is connected to the AV receiver.
• Output can be switched between Front high or Front wide speakers by pressing the [SP Layout] button (depending on the “Speaker
Configuration” setting (see page 102)).
*5 Depending on the input source, DTS is used.
• Available sampling rate for PCM input signal is 32/44.1/48/88.2/96/176.4/192kHz.
• The listening modes cannot be selected with some source formats.
To Next Page
Loading...
