5-12 PRO/100 LAN+Modem PC Card User’s Guide
c Enable Port by clicking box in that field.
3 Click Configure to configure the modem.
a Select your modem Speed under Modem Settings.
b Under Modem Type, select Hayes Generic.
c To modify the modem initialization string, which is usually not
necessary, click Customize and make any changes required. Click
OK, then Close.
d Enter the phone number(s) of your service provider and/or BBS
in the Connect over Modem window under Phone Number. Be
sure entries in Services and Security are correct for your envi-
ronment and/or the type of action you wish to exercise.
If too many programs are loaded via the LOAD or RUN statements in
your c:\windows\win.ini file, you will receive an Out of System Memory
Error when running LapLink. Correct this error by temporarily editing
out any special programs in those two statements. Make a backup copy of
the WIN.INI file before editing it. The load=c:\(Laplink
Directory)\llwload.exe line must reside in the WIN.INI, as it is required
for LapLink to work.
Operating inconsistencies will be experienced when Card and Socket
Services are used with LapLink. If you need to use LapLink, it is recom-
mended that Card and Socket Services not be used.
LapLink version 6.0 with Windows 95
To set up the Intel PRO/100 modem or modify the present configuration:
the steps are the same as those listed above for LapLink 6.0, except under
3.d.
1 In the Connect over Modem window under Dialing enter:
a The phone number(s) of your service provider and/or BBS
Phone Number.
b The location that you are dialing from under Dialing Location.
c Notice that in Connect Over Modem, Connect Using, the
To Next Page
Loading...
Need help?
General
