4-44 PRO/100 LAN+Modem PC Card User’s Guide
FRAME (ODI) designates support for multiple Ethernet
frame types. One or more types can be used. Refer
to your NetWare documentation for more
information. The Intel ODI drivers default frame
type is 802.2, but the NET.CFG file supplied with
the ODI driver on Disk 2, Network Drivers Disk
sets both 802.2 and 802.3. Therefore if your
networks frame type is 802.3, you must use Intels
NET.CFG with the ODI driver.
INTERRUPT specifies a LAN interrupt to use. It requires a
decimal value designating the PRO/100 PC Card
port hardware interrupt (for example, INT 5 or
INT 7). Default (if parameter not specified) is 5.
Any value supported by the PC Card hardware can
be used.
INTERRUPTNUMBERSee INTERRUPT.
IOADDRESS specifies the LAN I/O address to use, in hexadeci-
mal notation. Default address is 320.
IOBASEADDRESS see IOADDRESS.
IOWAITSTATES specifies the number of wait states that should be
added to I/O accesses to the card. Values are a
decimal number from 1 to 3. On some machines it
may be necessary for the driver to run with I/O
waitstates. By default, the driver will attempt to
automatically configure this parameter. The
keyword is provided as a troubleshooting aid.
LINKINTEGRITY ON or OFF. See LINKDISABLE.
LINKDISABLE disables the link integrity check on the network
twisted pair cabling (for operation with non-IEEE
10BASE-T networks such as StarLAN 10).
Without the LINKDISABLE keyword in the
driver command line, the driver defaults to link
integrity ENABLED.
To Next Page
Loading...
Need help?
General
