Windows 3.x/MS-DOS Installation 4-45
MEMORY specifies the memory location to use. It is specified
in hexadecimal notation and is not a segment
value. Specify the full address for all drivers. For
example, D2000, not D200. The PRO/100 PC
Card uses 4 Kbytes of memory (1000 hexadecimal)
for the LAN. Use the MODE IO setting to disable
MEMORY MODE. Default is D2000. Possible
values are C0000 through E0000.
MEMORYBASEADDRESS
see MEMORY.
MEMWAITSTATESspecifies the number of wait states that should be
added to memory accesses to the card. Values are
decimal 1 to 3. On extremely fast machines it may
be necessary for the driver to run with waitstates.
By default, the driver will attempt to automatically
configure this parameter. The keyword is provided
as a troubleshooting aid.
MODE specifies whether to run the network in memory-
mapped or I/O mode. Values are the ASCII
strings MEMORY or IO. The default setting is
MEM. Set this keyword to IO to disable requests
for memory-mapped mode on systems that only
support an I/O driven card.
NOCHECK disables verification of adapter resources. This
keyword is intended to be used as a troubleshoot-
ing tool.
NOCOM the PRO/100 PC Card driver will configure a
COM port by default. The NOCOM keyword can
be used to defeat this feature. If the keyword is not
used, the modem is enabled. LAN operations are
not affected.
NOEARLYRX disables Advanced Look-ahead Pipelining features
of the PRO/100 PC Card. You may need this
keyword for NDIS version 2.01 drivers which do
not fully support the early RX feature.
To Next Page
Loading...
Need help?
General
