35
Range between 133~500.
CPU Ratio
Use this item to set CPU ratio. Use+/- to select value.
CPU Vcore 7-Shift
Use this item to set value in CPU Vcore X-Shift function. The optional settings are:
+50mV to 350mV.
CPU PLL Select
Use this tem to set CPU PLL from 1.816V(Default) to 2.043V.
PCH 1.8V Voltage
Use this item to set PCH 1.8V from the range of 1.816V(Default) to 1.906V.
PCH Core Voltage
Use this item to set PCH core voltage from the range of 1.079 (Default) to 1.180V.
CPU VTT Voltage
Use this item to set CPU VTT voltage from 1.176V(Default) to 2.247V.
DRAM Voltage Select
Use this item to set DRAM voltage from 1.538V (Default) to 3.254V.
3-12 Password Setting
You can set either supervisor or user password, or both of them. The differences
are:
Change Supervisor password: Can enter and change the options of the setup
menus.
Change User password: Can only enter but do not have the right to change the
options of the setup menus. When you select this function, the following message
will appear at the center of the screen to assist you in creating a password.
Enter New Word:
Type the password, up to eight characters in length, and press <Enter>. The
password typed now will clear any previously entered password from CMOS memory.
You will be asked to confirm the password. Type the password again and press
<Enter>. You may also press <Esc> to abort the selection and not enter a
password.
To disable a password, just press <Enter> when you are prompted to enter the
password. A message will confirm that the password will be disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any part of
your system configuration.
To Next Page
Loading...
Need help?
General
