3
Reader User Manual
1
Charging the Battery
To charge the battery, plug your Reader into a power source. The Reader comes
with an AC power adapter and power cord. The power cord consists of two
sections, one of which is attached to the adapter. Connect the other section of the
cord to the adapter.
Plug the power cord into the power socket. When the display screen is facing up,
and the camera is pointing toward you, the power socket is located at the far right
of the bottom edge. Then plug the other end of the power cord into a wall outlet.
You can leave the Reader plugged in indenitely. You will not over-charge the
Reader by leaving it plugged in, though it is a good idea to unplug it if there is
danger of an electrical storm, to prevent damage to the Reader.
To Next Page
Loading...