Cables
Before installing the system cables, consider the following points.
• All cables need to be well clamped and protected from physical
damage
and exposure to heat and humidity.
• Cables with severe bends are not allowed.
• Where a cable passes through an exposed bulkhead or deckhead,
a watertight grommet or swan neck tube should be used.
Power Requirements
Follow the power requirements to avoid damage to the system.
The Intellian i3/i3L/i4/i4P has been designed to work on a boat’s power
supply rated from 9 ~ 30 V DC.
If your IRD(s) and television(s) require a 110V/240V AC power supply,
you will need to install a suitable DC to AC converter to operate the
unit(s) from your boat’s DC power supply.
RF Cable
This cable is supplied at a length of 49ft (15m). If a longer length is
required you should replace this cable with an extended RF cable
supplied by Intellian Technologies.
Extending the Cables
The cables that have been supplied with your Intellian system should be
of adequate length to complete the installation on most vessels.
Note: Exceeding the indicated cable lengths will result in reduced
performance of your system.
To Next Page
Loading...
Need help?
General
