Introduction
This section of the handbook describes how to setup your Satellite TV
System after installing the ACU. It includes the following functions:
• Start up.
• Changing target satellite.
• Monitoring the current status of the antenna.
• Sleep mode.
Setup Mode
• Begin setup mode.
• Setting the satellite pair.
• Setting GPS.
• Edit satellite information.
• Setting the antenna parameters.
• Setting the LNB local frequency.
• Setting the DiSEqC method.
• Display versions.
• Display power.
• Setting remote control.
• Setting antenna go position.
• Setting antenna move step.
• Executing antenna diagnosis.
• Setting region.
• Setting the factory default parameters.
Operation Instruction
Note: Many of the above functions will only be required only after
initial installation of your system. Refer to the Quick Installation Guide
before operating the system.
To Next Page
Loading...
