Intellian V110 - Operating the ACU; ACU Operation Modes Introduction

28
V110 – Marine Satellite Communication System
Operating the ACU
Introduction
This section of the handbook describes how to setup your system after
installing the ACU. It includes the following functions:
Normal Mode
System Startup
Monitoring Current Status
Setup Mode
Installation Setting
Select Satellite
Setting GPS and Gyrocompass
Setting Bow Adjustment
Setting Modem Connection
Setting LNB Local Frequency
Setting the Antenna
Setting Antenna Manual Search
Setting Antenna LNB Skew Angle
Setting Antenna Search Parameters
Setting Antenna Parameters
Setting Block Zone
Performing Diagnostic Tests
Setting the Satellite
Load Satellite
Edit Satellite Information
Add Satellite
Setting the System
Setting LNB Local Frequency
Setting GPS and Gyrocompass