Intellian V110 - Controller Menu

68
V110 – Marine Satellite Communication System
Signal Level: To display signal level. It shows “Tuner” when choose
DVB tracking mode and “NBD” when choose NBD tracking mode.
Product Ant: To display antenna model and “PCU” firmware version.
Product ACU: To display ACU model and “Main” firmware version.
Definition of Program Command Buttons
Restart: To exit setup mode and restart antenna again.
Setup: To enter the setup mode.
Get Antenna Information: To indicate the information on display after
receiving input from the antenna.
Factory Setting: To initialize all antenna information to default as it
was in the factory status.
Save Satellite: If the current settings are able to locate the satellite (in
Tracking mode), press this button to save the settings. It will shorten
the satellite acquisition duration next time
Backup: To backup antenna information to ACU.
Restore: To restore the antenna by using saved information in ACU.
Controller Menu
Position (GPS, Heading, Bow) & Manual Search
Antenna makes use of GPS and ship’s heading information to search
satellite faster. The more precise the GPS information is, the quicker the
antenna is able to search for the satellite. The method to input
information into GPS is to mark “Edit GPS” first and push “Set GPS”
button after keying in the latitude and longitude information.