Inter-m EMI-300 - Master 2 Output; Mono Subwoofer Output; Recording Output

15
EMI-300
7-CHANNEL 2 X 150W MIXING AMPLIFIER
Master 2 Out
This output has two balanced XLR connectors and always carries the stereo master signal, no matter what
operational mode you have selected. The level of this output depends on the setting of the MASTER 2 control.
If you are operating your EMI-300 in stereo mode, you can use the MASTER 2 output to connect another
power amplifier for increasing your available system power.
Mono Sub Out
This output has one balanced XLR connector and always carries a monaural low pass version of the master
signal, no matter what operational mode you have selected. The level of this output depends on the setting of
the MASTER 1 control. This output can be used to connect an active subwoofer or power amplifier for an
enhanced bass reproduction of your sound system.
REC Out
This output h
Master 2 Out
This output has two balanced XLR connectors and always carries the stereo master signal, no matter what
operational mode you have selected. The level of this output depends on the setting of the MASTER 2 control.
If you are operating your EMI-300 in stereo mode, you can use the MASTER 2 output to connect another
power amplifier for increasing your available system power.
Mono Sub Out
This output has one balanced XLR connector and always carries a monaural low pass version of the master
signal, no matter what operational mode you have selected. The level of this output depends on the setting of
the MASTER 1 control. This output can be used to connect an active subwoofer or power amplifier for an
enhanced bass reproduction of your sound system.
REC Out
This output has two RCA-type phono connectors and can be used for recording of all line and microphone
signals. This output is not affected by the setting of the MASTER EQ and MASTER VOLUME controls and works
in every operational mode.