AA222 Instructions for Use – US Page 11
2.4.1 Changing probe system
Change between the standard and clinical probe as follows:
1. Locate the probe connection on the back of the unit.
2. Open the 2 locks by pushing them to the sides.
3. Swap to the other probe system.
4. Close the 2 locks by pushing them to the center.
2.4.2 Safety precautions to take when connecting the AA222
Please note that if connections are made to standard equipment such as printers and networks, special
precautions must be taken in order to maintain medical safety. Please refer to section 2.3.
Use only specified power supply unit UE60-240250SPA3 type.
WARNING
WARNING
To Next Page
Loading...
Need help?
General
