AA222 Instructions for Use – US Page 21
License
A
AUD key. When pressing the button a pop up window opens in which you can
enter a new license key for the audiometry module. The new license key is activated by pressing
the button. The previous license key will not get changed if the new key is not
a valid key.
B
IMP key. When pressing the button a pop up window opens in which you can
enter a new license key for the impedance module. The new license key is activated by pressing
the button. The previous license key will not get changed if the new key is not
a valid key.
Light
C
The Display light can be changed by holding the button and rotating the
wheel. You will see the brightness of your screen change according to this setting.
D
The LED light can be changed by holding the button and rotating the wheel.
You will see the brightness of the LEDs around the Enter button change according to this
setting. Note that the LED in the probe system cannot be adjusted.
Session settings
E
Keep session on save will keep the session on the device when pressing save session.
System
F
When pressing the button while Date and time is selected you can manually
alter the date and time. The following window will pop up
Use the wheel to select day, month, year, hour or minutes. Use the and
buttons to adjust the number. Press the button to keep
changes and set date and time or press the button to reject any change made.
If the AA222 is connected to the Diagnostic Suite, your PC will automatically update the date and
time.
Printer
G
Under Printer type you can select which printer is connected to the USB port of your AA222. By
default, the Sanibel
TM
MPT-III thermal printer is selected. The list below shows the printers
currently supported.
To Next Page
Loading...
Need help?
General
