110 TruVision NVR 10 User Manual
Figure 30: System information (Network window shown)
To view system information:
1. From the menu toolbar, click System Settings > System Information.
2. To view device information, click the Device Info tab (1).
You can view the device name, model, serial number, firmware version, and
encoding version.
3. To view camera information, click the Camera tab (2).
You can view the status of each camera: camera number, camera name, status,
motion detection, video tampering, and video loss,
4. To view the recording status and encoding parameters of each camera, click the
Record tab (3).
You can view camera number, recording status, stream type, frame rate, bit rate
(Kbps), resolution, record type, and encoding parameter.
5. To view the alarm information, click the Alarm tab (4).
You can view the alarm input and alarm output numbers, alarm name, alarm type,
alarm status, and triggered camera.
6. To view network information, click the Network tab (5).
You can view the IPv4 address, IPv4 subnet mask, IPv4 default gateway, IPv6
address 1, IPv6 address 2, IPv6 default gateway, preferred DNS server, alternate
DNS server, enable DHCP, enable PPPoE, PPPoE address, PPPoE subnet mask,
PPPoE default gateway, and MAC address.
7. To view HDD information for each HDD, click the HDD tab (6).
You can view the HDD label, status, capacity, free space, property, type, and group.
8. Click Back to return to live view.
To Next Page
Loading...
