44 TruVision NVR 10 User Manual
To setup video loss detection:
1. From the menu toolbar, click Camera Management > Video Loss.
2. Select a camera to configure for video loss detection.
3. Check the Enable Video Loss Alarm box to enable the feature.
4. Click the Rule button to enter the Rule window.
5. Click the Rule tab. Select how you want the NVR to notify you of video loss. Click
Apply to save the settings and then OK to return to the previous window.
6. Click the Arming Schedule tab and select the schedule when you want video loss
detection to be enabled. Schedules can be set for all week or any day of the week
with up to eight time periods per day.
7. Click the Apply button to save settings.
8. Click Copy to copy the settings to other days of the week and holiday period.
Note: The time periods defined cannot overlap
9. Click OK to return to the Video Loss window.
10. Click Back to return to live view, or continue configuring the NVR settings.
Detecting video tampering
Video tampering, such as moving a camera to a different position, can also be detected
and set to trigger an action on the NVR. Not all IP cameras may support this feature.
Note: It is strongly recommended not to configure for video tampering when using PTZ
dome cameras.
To set up video tampering detection:
1. From the menu toolbar, click Camera Management > Tamper Mask.
2. Select a camera to configure for tamper-proof.
3. Check the Enable Tamper Mask box to enable the feature.
4. Define a tampering detection area.
The tamper detection area setup interface lets you define an area on-screen where
you want camera tampering to be detected. Click and drag the mouse across an
area to mark that area for video tampering. You can only set one tampering area
with the full screen being the maximum area. Click Clear to clear the window.
To Next Page
Loading...
