36 TruVision NVR 10 User Manual
Setting the HDD to read-only
When you set an HDD to read-only, recorded video files cannot be written to the HDD.
If multiple HDDs are used, the NVR automatically records to the next HDD not set to
read-only
To set an HDD to read-only:
1. From the menu toolbar, click System Settings > Hard Disk.
2. Select the HDD you want to set to read-only.
3. Click the Edit button for the selected HDD.
4. Check Read only.
5. Click Apply to save the settings. The HDD is now read-only.
Note: In order to enable recordings on that particular HDD again, you must set the
HDD status back to R/W (Read/ Write). Make sure the HDD storage mode is
"Group" before setting the HDD to read-only.
6. Click Back to return to live view, or continue configuring the NVR settings.
To Next Page
Loading...
